Use of Night Lighting Continues to Grow

December 11, 2017

From 2012 to 2016, Earth’s artificially lit outdoor area grew by 2.2% per year, with a total radiance growth of 1.8% per year, reports an article published in the journal Science Advances. Continuously lit areas brightened at a rate of 2.2% per year. Researchers observed large differences in national growth rates, with lighting remaining stable or decreasing in only a few countries. These data are not consistent with global scale energy reductions, indicating instead greater light pollution, with negative consequences for flora, fauna, and human well-being.

Historically, increases in luminous efficacy have led to greater light use rather than energy savings, notes the article. A critical question for sustainable development is whether the use of outdoor light will continue to grow exponentially or whether developed countries are nearing saturation in demand.

The researchers question whether, if demand saturation has not been reached, the increasing luminous efficacy made possible by the solid-state lighting revolution (12) will increase light emissions instead of saving energy.

The research was conducted using data from Visible Infrared Imaging Radiometer Suite Day-Night Band (VIIRS DNB), which came online just as outdoor use of LED lighting began in earnest. This sensor provides the first-ever global calibrated nighttime radiance measurements in a spectral band of 500 to 900 nm, which is close to the visible band, with a much higher radiometric sensitivity than previous methods. This improved spatial resolution allows for neighbourhood (rather than city or national) scale changes in lighting to be investigated .

Results

The data show that over the period of 2012-2016, both lit area and the radiance of previously lit areas increased in most countries in the 500–900-nm range, with global increases of 2.2% per year for lit area and 2.2% per year for the brightness of continuously lit areas. These factors decreased in very few countries.

Many large cities had decreases in DNB radiance in the city centre but increases in outlying areas. These decreases can often be directly attributed to replacement of older lamps with LEDs. This is vividly demonstrated by photographs of Milan, Italy, taken by astronauts on the International Space Station in 2012 and 2015. The streetlights in the city changed from yellow/orange (sodium vapour) to white (LED), whereas the surrounding areas remained yellow/orange. As a result, the radiance observed by the DNB decreased because of the sensor’s lack of sensitivity to light in the range of 400 to 500 nm

Discussion

Two major arguments for changing to LEDs for outdoor lighting are cost savings and reductions in energy consumption. These goals have been realized in many cities, so decreases in observed DNB radiance likely indicate local energy savings. However, on a global and often national scale, these local decreases are outweighed by increases in radiance in other areas, most likely because of additional lighting being installed. The “energy saving” effects of outdoor LED lighting for country-level energy budgets are therefore smaller than might be expected from the increase in luminous efficacy compared to older lamps

Large differences in per capita light use compared to per capita GDP suggest that in brightly lit countries, major decreases in energy consumption for outdoor lighting could potentially be achieved through reduced light use.

In the near term, it appears that artificial light emission into the environment will continue to increase, further eroding Earth’s remaining land area that experiences natural day-night light cycles. This is concerning, because artificial light is an environmental pollutant. In addition to threatening the 30% of vertebrates and more than 60% of invertebrates that are nocturnal, outdoor artificial light also affects plants and microorganisms, and is increasingly suspected of affecting human health. In the longer term, perhaps the demand for dark skies and unlit bedrooms will begin to outweigh the demand for light in wealthy countries

Read the study here: http://advances.sciencemag.org/content/3/11/e1701528.full

Related Articles


Changing Scene


Design

  • LEDVANCE: Understanding Light Beam Angles

    LEDVANCE: Understanding Light Beam Angles

    Beam angle is important in lighting design. It determines how light spreads within a space and influences both functionality and atmosphere. By understanding beam angles, you can achieve both adequate coverage and visual appeal. This guide explains why beam angle matters, how it affects different types of lighting, where it is applied, and what to… Read More…

  • Canada Light Expo: Energy Efficient Lighting Solutions for Modern Businesses

    Canada Light Expo: Energy Efficient Lighting Solutions for Modern Businesses

    In today’s competitive business landscape, organizations are constantly seeking ways to reduce operational costs, improve sustainability, and foster productive work environments. Among the most impactful yet often overlooked areas of optimization is lighting. As businesses strive to balance profitability with environmental responsibility, energy efficient lighting has emerged as a strategic investment rather than just a utility… Read More…


New Products

  • JDRF Electromag: The Autonomy Touch Screen – Lighting Control Solution

    JDRF Electromag: The Autonomy Touch Screen – Lighting Control Solution

    The Autonomy Touch Screen automatically pairs with co-located sensors and updates the GUI based on the lighting arrangement grouping configuration. Users can pair their smartphone to the Touch Screen through NFC with a simple tap to gain access to the lighting system from the mobile application. The Touch Screen provides a visual interface to control… Read More…

  • Eralux: ALPS E3 HYDRO – Backlit Flat Panel

    Eralux: ALPS E3 HYDRO – Backlit Flat Panel

    The ALPS E3 series is a backlit flat panel designed with optimal LED placement to ensure a uniformly lit space. It features a switchable CCT and power driver that allows endless flexibility at the install site, as well as a 125 LPW performance. The additional Level 2 NSF rating of the ALPS E3 HYDRO makes… Read More…