WCY Cylinder Wall Mount- Uplight, Downlight or Bidirectional from Stanpro

BeLuce’s Centro system is an all-in-one solution, especially when reliability is the most important feature of any emergency power source. Without it, all other features and benefits are meaningless. Fortunately, there is now an innovative and reliable solution that greatly simplifies the installation process and considerably reduces the cost of material, labour, monitoring and maintenance. Normally on signs and normally off remotes must operate independently on the building’s power during a power failure. It thus requires two different cables to connect the emergency fixtures. A third wire is essential to allow communication
between the units. It, therefore, generates important material and labour costs, especially for large/vast buildings where running thousands of feet of wires are needed. The Centro system is the perfect solution to reduce those costs because it only involves a single cable instead of three. The Centro drivers within each unit will determine what is normally off or normally on in the circuit. It also permits communication between the units and the Centro Software.

BeLuce’s Centro system is an all-in-one solution, especially when reliability is the most important feature of any emergency power source. Without it, all other features and benefits are meaningless. Fortunately, there is now an innovative and reliable solution that greatly simplifies the installation process and considerably reduces the cost of material, labour, monitoring and maintenance. Normally on signs and normally off remotes must operate independently on the building’s power during a power failure. It thus requires two different cables to connect the emergency fixtures. A third wire is essential to allow communication
between the units. It, therefore, generates important material and labour costs, especially for large/vast buildings where running thousands of feet of wires are needed. The Centro system is the perfect solution to reduce those costs because it only involves a single cable instead of three. The Centro drivers within each unit will determine what is normally off or normally on in the circuit. It also permits communication between the units and the Centro Software.