Cristal: CC-ZIN Controller for Lighting Control Relays
February 13, 2025
Cristal: CC-ZIN Controller for Lighting Control Relays
Description
Cristal’s CC-ZIN is a simple stand-alone controller for lighting control relays.
- New CC-ZIN features 2 independent outputs and 2 independent inputs, that can be assigned to control WR-6161 relays.
- Each output can control up to 4 Wr-6161 relays for a total of 8 per CC-ZIN.
- The CC-ZIN settings are done using the jumpers’ section.
- The 2 outputs can be set using jumpers either to controls WR-6161 Panasonic relays or to hold 24 Vac signal.
- The 2 independent inputs can accept the following signals:
- Dry contact
- 5-30Vca-cc
- Motion sensors
Applications
- The CC-ZIN is used to control 2 zones at the same time. The inputs can be set as “On” only or “Off” only.
- Many type of control devices can be connected to the inputs : Astronomical time clock, photocell, motion sensor, dry contact switch.
- The CC-ZIN has been design with easy to use jumpers for all settings.
Features
| Supply | 24 VAC, with a typical consumption 25 mA and a maximum consumption of 200 mA during a change of state (1 relay WR6161 per output) |
| Ouputs | – 2 X 24 Vac rectified positively or negatively for Panasonic low-voltage relay or 24Vac continuous. – 2 X 24VDC halfwave to power detectors, max 200mA combined. – Up to 4 relays per output or 200mA in continuous 24Vac mode. |
| Inputs | 2x high impedance (80 KΩ). |
| Dimensions | – Assembly unit in 35mm DIN rail housing. Designed for factory installation in a Crystal Panel Controls. – 3.5″ X 2.2″ X 0.7″ |
