LED Tech

It is critical to put the consumer at the center of the discussion, says new report that sets out a measured response plan the industry can use to fast-track solutions.

Pierre Longtin, President of Nyx Hemera, was proud to announce the installation of TLACS-A, the outdoor site control solution that uses a power carrier, in the Bolton Tunnel in Vermont.

Some of the recent blog posts have described different components in Networked Lighting Control (NLC) systems. We’ve talked a lot about the building blocks that are needed to create lighting systems that feature some kind of ability to change colors – either “dim-to-warm,” “tunable-white,” or even “full color-changing (RGB)” type systems.

The Alberta Electrical Association (AEA) held their first virtual Learning Expo this past week, which allowed them to continue their programming safely and bring a sense of normal in the otherwise uncertain times of a global pandemic.

Every day, Canadian companies struggle to reduce their carbon footprint without increasing their bottom line.

The Northwest Energy Efficiency Alliance (NEEA) recently published a study seeking to compare one-for-one luminaire level lighting control (LLLC) retrofits with a comprehensive networked lighting controls (NLC) redesign.

A new study by the Lighting Research Center (LRC) demonstrates that 40 Hz red light stimulation delivered to open eyes of healthy young adults increases brain gamma oscillations.

The rising demand for a strong surveillance system worldwide is likely to boost IR LED market growth over the coming years.

Scientists at the Circadian Light Research Center have identified the narrow band of blue light that synchronizes our circadian rhythms during the day and disrupts them at night.

The U.S. Department of Energy has released the results of a study examining authentication vulnerabilities in connected lighting systems (CLS).

While DMX is an industry standard and a workhorse protocol for dynamic lighting controls that is agnostic to manufacturers, there can be a lot of on-site programming and additional wiring required to be effective.